Instructions for ordering a diving mask with corrective lenses

1. Selection of the Diving Mask and Preparation for Measurements

Select the diving mask model on which the measurements will be performed and which will be ordered. Measurements must be carried out on the same mask model that will be used for lens installation.

Preparation for Measurements:
- Put on the selected mask model.
- Mark the position of the pupil on the lens with a marker while looking straight ahead.
- If ordering lenses for near vision, additionally draw a horizontal line indicating the lower edge of the lens.
- Optionally, apply transparent tape to the lens to check if the lens edge interferes during diving, taking your personal preferences into account.
- If you are using a test mask, leave the markings on the lens — do not remove them.

Taking the Photo:
- Take a photo of your face wearing the mask, holding the camera at eye level.
- Look straight ahead and maintain a natural, upright posture.
- Ensure that the pupils and the markings are clearly visible in the photo.

Submitting the Photo:
- Upload the completed photo via the order form or send it to kontakt@maskinurkowe.pl, including your order number.

Test Mask:
- If you are unable to perform measurements on the selected model, we will send you a test mask after placing the order.
- Shipping depends on the lens design and the prescription values.
- The cost of return shipping is covered by the ordering party.

Choosing the Mask Color:
- After completing the measurements, select the mask color and proceed to finalize your order.